Available now for the 2010+ Camaro is our 3-1/2 aluminum shaft with CV. We have done extensive testing with stock rears and with our 9" kit and believe this to the the most cost effective trouble free drive shaft for the Camaro available today. The shaft will come with our signature billet plates for each end so you done have to go in to the rear taking a chance on upsetting the crush collar. Our shaft comes with a 300m stub system mounted into a billet aluminum plate to ensure not only strength but lighter weight than the normal way of doing this type of end.The shaft only weighs 17lbs and come with special 12.9 uber strength hardware with back up lock nuts to ensure no loose bolts.

You will have to remove the heat shield from above center hanger mount to install a 3-1/2" shaft. There is a possibility of clearance issues with aftermarket exhaust. This is just a general warning for liability purposes. We have 9 test shafts out, and not one had an issue. I have listed this because not all exhaust systems have been tested.